GF07.61-P-0001-01F | Fuel injection and ignition system motor electronics (ME-SFI) arrangement of components | MODEL 210 with ENGINE 104 with CODE (491) USA version with CODE (498) Japan version |
P07.61-0281-06
On engine
B2/5 Hot film MAF sensor with IAT sensor
B6/1 Camshaft Hall-effect sensor
B11/4 ECT sensor (DFI, IFI)
B28 Pressure sensor ( only)
L5 CKP sensor
M16/6 Throttle valve actuator
T1/1 Ignition coil 1 (cylinders 2 and 5)
T1/2 Ignition coil 2 (cylinders 3 and 4)
T1/3 Ignition coil 3 (cylinders 1 and 6)
Y22/6 Resonance intake manifold switchover valve
Y49 Adjustable camshaft timing solenoid
Y62 Fuel injectors (LH-SFI, HFM-SFI, PEC)
P07.61-0280-06
On engine
A16 Knock sensors
M33 AIR pump (only and low-emission D3 as of 07/97)
S43 Oil level switch
Y32 AIR pump switchover valve (only and low-emission D3 as of 07/97)
P07.61-0305-06
In engine compartment
Model 210 only
B37 Pedal value sensor
K40 Relay module with:
FP relay
Secondary air injection relay
N3/10 Engine control module (ME-SFI)
X11/4 Data link connector (DTC readout) (38-pin) (pulse signal)
P07.61-0288-06
In engine compartment
Model 210 only
B4/3 Fuel tank pressure sensor ( only)
Y58/1 Purge control valve
Y58/4 Activated charcoal canister shut-off valve ( only)
77 Activated charcoal canister
P07.61-0289-06
In engine compartment
Model 210 only
A1e26 "CHECK ENGINE" MIL ( only)
G3/1 O2S 2 (after TWC) ( only)
G3/2 O2S 1 (before TWC)
X11/22 Data link connector II ( only)
P07.51-0336-01
In engine compartment
Model 210
Y3/3 Upshift delay switchover valve
Y4 Transmission mode switchover valve
Y58/1 Purge control valve