Install transport foil

AR97.20-S-4000S

Install transport foil

06.12.2019

Model

636, 639

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Notes on transportation sheeting

AH97.20-P-9409-03A

1

Remove old foils

If installed.


Heat surfaces to be machined
but not so much that they can no longer be touched. Increased temperature can cause paint damage.

 Removal can be facilitated by heating.

2

Clean vehicle

 Buff wet vehicles until they are dry.

3

Check surface of vehicle

 Visible edges of the tape can remain (when performing a reapplication). These edges are removed during paintwork preparation at the sales centers (VPC) or dealerships.

 Minor swelling during reapplication is insignificant. The new foil can be applied to these painted surfaces.

4

Apply new transportation foil


Do not mask plastic parts and rubber profiles with foil.
Otherwise glue residues may be present.

 The new transport foil is applied manually.