1 | Airbag unit |
2 | Steering wheel |
3 | Access opening |
4 | Retaining clips |
5 | Electrical connector |
S91.60-4580-06
2 | Steering wheel |
3 | Access openings |
4 | Retaining clamp |
S91.60-4620-06
3 | Access opening |
4 | Retaining clamp |
S91.60-4621-11
Danger ! | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | |
| Notes on carrying out repair work in the vehicle interior | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | ||
| Assessment of airbag and belt tensioner units in accident vehicles | ||
| Remove/install | ||
1 | Turn steering wheel (2) into center position | ||
2 | Disconnect battery ground line | ||
3 | Punch through access openings (3) on steering wheel (2) using a Torx screwdriver T20 | When removing the airbag unit (1) for the first time. | |
4 | With the Torx screwdriver T20 through access openings (3) release retaining clip (4) on both sides and remove airbag unit (1) from steering wheel (2) | Installation: The retaining clip (4) must audibly engage. | |
5 | Disconnect electrical connection (5) | Installation: Ensure that electrical connector (5) is locked correctly. | |
6 | Install in the reverse order | ||
| Check | ||
7 | Perform function test on left and right horns |