1 | Airbag/emergency tensioning retractor control unit |
2 | Electrical connectors |
3 | Screw |
4 | Bracket |
S91.60-4649-06
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Remove center console | ||
2 | Disconnect battery ground line | ||
3 | Separate electrical connectors (2) | ||
4 | Remove screws (3) | Bolt, airbag control unit to vehicle floor | |
5 | Remove airbag/seat belt tensioner control unit (1) with holder (4) | ||
6 | Install in the reverse order | ||
7 | Perform initial startup of airbag/seat belt tensioner control unit (1) | When replacing airbag/seat belt tensioner control unit (1). | |
| |||
| Check | ||
8 | Check Supplemental Restraint System (SRS) with diagnostic system | When reusing airbag/seat belt tensioner control unit (1) | |
|