Shown on model 218 |
1 | Driver airbag |
2 | Steering wheel |
P91.60-4159-06
Shown on model 218 |
1 | Driver airbag |
3 | Plug |
4 | Lock tabs |
5 | Electrical connectors |
6 | Retaining plate |
7 | Retaining springs |
P91.60-4158-06
Warning | Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | |||
| Remove/install | ||
1 | Place steering column in the central height position | ||
2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | ||
3 | Disconnect ground line of battery |
| |
Model 204.0/2 | |||
Model 207, 212 | |||
Model 231 | |||
Model 117, 156, 176, 242, 246 | |||
Model 190 | |||
4 | Determine position of openings through careful application of the Torx screwdriver of size T20 | When removing driver airbag (1) for first time. | |
5 | Pierce openings using Torx screwdriver of size T20 | When removing driver airbag (1) for first time. | |
6 | Insert Torx screwdriver into openings on steering wheel (2) and press retaining springs (7) inward | Installation: | |
7 | Remove driver airbag (1) far enough from steering wheel (2) until the plug (3) is accessible | ||
8 | Release and disconnect plug (3) from steering column tube module | ||
9 | Remove driver airbag (1) from steering wheel (2) | ||
10 | Install in the reverse order | ||
| Check | ||
11 | Check and erase vehicle fault memory using the diagnostic vehicle diagnosis system | When replacing the driver airbag (1). | |
| Model 117, 156, 172.4, 176, 204.3, 218, 231, 242, 246 | ||
| Model 190 |