1 | Stowage box/tray |
2 | Bolts |
3 | Retaining clips |
4 | Connector |
5 | Front passenger airbag |
6 | Bolts |
7 | Retaining clips |
D91.60-1133-06
| Remove/install | ||
Warning | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Topical note | Notes on performing repair, body work and welding on vehicles with airbags and RTE units | ||
Legal requirements on handling and storing airbags and emergency tensioning retractor units | |||
Assessment of airbag and belt tensioner units in accident vehicles | |||
1 | Remove ignition key from ignition lock | ||
2 | Unclip front stowage box/tray (1), lift slightly and remove toward front | ||
3 | Unscrew retaining clip (3) | Installation: Pay attention to installation position. | |
4 | Remove bolts (6) | Installation: Replace bolts (6). | |
Bolt, front passenger airbag to bracket | |||
5 | Remove front passenger airbag (5) from the bracket a little until connector (4) on the right side is visible | ||
6 | Disconnect plug (4) from squib at gas generator | Installation: Connector (4) must audibly snap in. | |
When replacing the airbag unit, ensure proper and environmentally friendly disposal. | |||
7 | Install in the reverse order | ||
8 | Connect diagnostic system and perform quick test | ||
9 | Read out fault memory of airbag (AB) system and delete fault memory |