D91.60-0001-05
| Remove/install | ||
Warning | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.Model 901.0/3/4, 902.0/3/4, 903.0/3/4, 904.0/3/4 | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Topical note | Notes on performing repair, body work and welding on vehicles with airbags and RTE units | ||
Legal requirements on handling and storing airbags and emergency tensioning retractor units | |||
Assessment of airbag and belt tensioner units in accident vehicles | |||
1 | Remove ignition key from ignition lock | ||
2 | Remove two screws/bolts (2) | Bolt, airbag to steering wheel | |
Screwdriver bit | |||
3 | Lift airbag unit from steering wheel and disconnect connector (arrow) from the squib at gas generator | ||
4 | Remove airbag unit from steering wheel | When replacing the airbag unit, ensure proper and environmentally friendly disposal. | |
5 | Replace steering wheel | Only if the airbag unit was triggered. | |
6 | Install in the reverse order | ||
7 | Check the automatic resetting of the combination switch | ||
8 | Connect diagnostic system and perform quick test | ||
9 | Read out fault memory of airbag (AB) system and delete fault memory |
126 589 00 10 00
Screwdriver bit