1 | Automatic belt retractor |
2 | Squib connector coupling |
3 | Screw |
4 | Seat belt guide |
5 | Cover |
6 | Screw |
L91.40-0002-06
| Remove/install | ||
Warning | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | |
Topical note | Notes on performing repair, body work and welding on vehicles with airbags and RTE units | ||
Assessment of airbag and belt tensioner units in accident vehicles | |||
Legal requirements on handling and storing airbags and emergency tensioning retractor units | |||
1 | Withdraw ignition key | ||
2 | Remove side wall lining | ||
3 | Unclip cover (5) at seat belt guide (4) | ||
4 | Remove screw (6) and remove seat belt guide (4) at C-pillar | Bolt, belt guide bracket to bracket | |
5 | Disconnect squib connector coupling (2) and place to one side | Installation: Pay attention to the routing of the line (arrow). | |
6 | Remove screw (3) and remove seat belt retractor (1) upwards | Dispose of defective airbag unit and seat belt tensioner properly and in an environmentally-appropriate way. | |
Installation: Ensure correct seating in the guide | |||
Bolt to rear automatic belt retractor | |||
7 | Install in the reverse order | Check retaining clips and clamps. | |
8 | Check seat belt retractor and seat belt buckle for proper operation |