Shown on driver's seat in model 470.### 2# except code SF1 (Electrically adjustable driver's seat) |
1 | Front seat |
2 | Cover |
3 | Bolts |
4 | Trim Panels |
5 | Bolts |
S91.10-4626-06
S91.10-4627-08
Shown on driver's seat in model 470.### 2# except code SF1 (Electrically adjustable driver's seat) |
6 | Electrical connector | 8 | Electrical connector | 10 | Mounting clip | ||
7 | Electrical connector | 9 | Electrical wiring harness | 11 | Guide bolts |
Warning | Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | |||
| Remove/install | ||
1 | Move seat backrest of front seat (1) to upright position. | ||
2 | Fully retract head restraint of front seat (1). | ||
3 | Move steering wheel all the way upwards. | When removing the front seat (1) on the driver's side. | |
4 | Move front seat (1) to center position. | ||
5 | Remove trim (2). | Long wedge | |
6 | Unscrew bolts (3). | Bolt, front seat to vehicle floor | |
7 | Remove fire extinguisher with holder. |
| |
8 | Move front seat (1) all the way to the front. | ||
9 | Remove trims (4). | Long wedge | |
10 | Remove bolts (5). | Bolt, front seat to vehicle floor | |
11 | Detach ground line of on-board electrical system battery. | ||
12 | Remove electrical connectors (6, 7, 8). | ||
13 | Loosen retaining clip (10) and expose electrical wiring harness (9) on front seat (1). | ||
14 | Cover entrance area. | ||
| 000 588 08 98 00 Cover | ||
15 | Carefully remove front seat (1) from the vehicle with a helper. | | |
Installation: Make sure that the rubber disk is pulled onto the guide pin (11) and that the guide pin (11) is inserted into the guide hole (arrow) in the underbody. | |||
16 | Install in the reverse order | ||
Calibrate | |||
17 | Calibrate seat occupancy recognition. | After removal of front seat (1) on front passenger side. | |
| |||
Before deleting the airbag fault memory, calibrate the Weight Sensing System (WSS) control unit. | |||
| Check | ||
18 | Check Supplemental Restraint System (SRS) using vehicle diagnosis system. | ||
| |||
19 | Check front seat (1) for proper operation. | Scope of function test depends on equipment installed. |
115 589 03 59 00
Long wedge