P88.80-0224-06
Illustrated on model 208.3
1 A-pillar paneling
2 Rubber channel
3 Screw
4 Slider
5 Sheet metal clip nut
6 Clip
7 Holder
P88.80-0227-04
1 A-pillar paneling
2 Rubber channel
4 Slider
8 Clips
| Removal | ||
1 | Fold back wiper arm | Only model 208 | |
2 | Lift rubber channel (2) in lower area | ||
3 | Unscrew screw (3) | ||
4 | Release slide (4) upward (arrows) | ||
5 | Pull off paneling (1), lift at bottom and remove from holders (7) at top (arrows) | ||
6 | Put down paneling (1) | ||
| Installation | ||
7 | Check rubber channel (2), slider (4) and clips (8) on paneling (1) and position slider (4) to removal position | Replace damaged parts | |
8 | Check sheet metal clip nut (5), clips 6) and holder (7) on A-pillar | Replace damaged parts | |
9 | Move paneling (1) into upper holder (7) with mount, then press paneling (1) onto clips (6) and (8) | ||
10 | Lift rubber channel (2) in lower area and pull slider (4) down (to lock) | ||
11 | Screw screw (3) into sheet metal clip nut (5) | ||
12 | Press knob (arrow) on rubber channel (2) into oblong hole in slider (4) (arrow) | ||
13 | Align rubber channel (2) |
Long wedge
115 589 03 59 00