Remove/install front bumper

AR88.20-P-2000XG

Remove/install front bumper

05.07.2019

Model

463

as of model year 2019

Shown on model 463.260 without code C75 (stainless steel ram protection)

1

Front bumper

3

Bolts

2

Fender liner in front fender

X26/38

Front bumper electrical connector

Shown on model 463.260 without code C75 (stainless steel ram protection)

1

Front bumper

7

Expansion rivet

4

Bolts

Shown on model 463.260 without code C75 (stainless steel ram protection)

1

Front bumper

6

Catch hook

5

Catch hook

X26/38

Front bumper electrical connector

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Raise vehicle using vehicle lift.

AR00.60-P-1006A

2

Remove bullbar bumper.

Model 463 (except 463.276/277)
as of model year 2019
with code C74 (Impact protection,painted black)
Model 463 (except 463.276/277)
as of model year 2019
with code C75 (Stainless steel brush guard)

AR88.30-P-0025XG

Model 463.276/277
as of model year 2019
with code C74 (Impact protection,painted black)
Model 463.276/277
as of model year 2019
with code C75 (Stainless steel brush guard)

AR88.30-P-0025XGA

3

Unscrew screws (4) from the front bumper.

4

Remove expansion rivet (7) from the front bumper.

 Clip remover

*452589016300

5

Lower the vehicle.

AR00.60-P-1006A

6

Loosen the fender liner in the front fender (2) until the front bumper electrical connector (X26/38) and the screws (3) are accessible.

AR88.10-P-1300XG

 Do not remove wheel and tire assemblies.

7

Disconnect the front bumper electrical connector (X26/38) from the right of the front bumper (1).

8

Remove screws (3) on left and right of front bumper (1).

9

Unlock the catch hook (5) from the front bumper (1) on the left and right.

10

Unlock the catch hook (6) on the front bumper (1).

11

Lower the sides of the front bumper (1) downwards and remove the front bumper (1) to the front.


Note wheel arch liner when lowering.
Otherwise, the wheel arch liners will be damaged.

 Helper required.

12

Install in reverse order.