1 | Fender |
2 | Cover |
3 | Screw |
4 | Screw |
S88.10-4531-06
1 | Fender |
5 | Bolts |
6 | Screw |
7 | Bolts |
S88.10-4532-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
| Remove | ||
1 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
2 | Using suitable tape, mask off areas of front door that are directly adjacent to fender (1) to be removed. | ||
3 | Remove corresponding front fender. | ||
4 | Remove washer fluid reservoir of windshield washer system. | When removing right fender (1). | |
5 | Remove corresponding front lamp unit. | ||
6 | Unclip corresponding trim (2) and remove downwards. | ||
7 | Open corresponding front door. | ||
8 | Loosen bolt (3) a few turns. | ||
9 | Unscrew bolt (4). | ||
10 | Remove bolts (5). | ||
11 | Disconnect adhesively bonded connections in areas (A, B). | | |
12 | Remove screw (6). | ||
13 | Remove screws (7). | ||
14 | Remove fender (1). | ||
| Install | ||
15 | Remove loose residues of residual adhesive material at A-pillar. | ||
16 | Remove loose residues of residual adhesive material at fender (1). | When reinstalling fender (1). | |
17 | Apply adhesive to areas (A, B) on inside of fender (1). | When reinstalling fender (1), apply adhesive to existing residual adhesive material. | |
2K polyurethane foam TEROSON PU 9161 AF | |||
18 | Position fender (1) on vehicle. | | |
19 | Manually slightly screw in screws/bolts (3, 4, 5, 6, 7). | ||
20 | Align fender (1). | Gap dimensions | |
Gap dimensions | |||
Feeler gauge | |||
21 | Tighten screws/bolts (3, 4, 5, 6, 7). | ||
Topical note | General notes on touch-up applicators and paint spray cans | ||
Bolt, front fender to headlamp mount | |||
Bolt, front fender to engine hood hinge | |||
Bolt, front fender to body | |||
If paint damage exists at screws/bolts (3, 4, 5, 6, 7): | |||
| |||
Touch up paint damage with suitable touch-up paint pen. | |||
Use only Daimler AG approved touch-up paint pens: | |||
22 | Install trim (2). | ||
23 | Close front door. | ||
24 | Supplement cavity preservation. | ||
25 | Apply underbody protection in area of bolts (5). | ||
Underfloor protection 800 ml | |||
26 | Install windshield washer system washer fluid reservoir. | When installing the right fender (1). | |
27 | Install front lamp unit. | ||
28 | Install front fender liner. | ||
| Clean | ||
29 | Remove tape applied on front door and clean repair area. |
129 589 03 21 00
Feeler gauge