ar8330p5520glc

Remove/install expansion valve

ประเภท ar · หัวข้อ 83.30 · เวอร์ชัน 0104 · 2011-12-01

ใช้กับ: MODEL 461.331 with CODE (H02) Air conditioning

ไม่มีใน “th” แสดงเป็น อังกฤษ

ตำแหน่ง

กลุ่มฟังก์ชัน 3 Body › 83 Climate control › 83.30 Air conditioning — ซีรีส์ 461 (รุ่น 331)

EinPAS 39 Heating/ventilation/cooling › 39.15 Climate control › 39.15.13 Line/hose/valve — ซีรีส์ 461 (รุ่น 331)

AR83.30-P-5520GLC

Remove/install expansion valve

15.11.11

MODEL 461.331 with CODE (H02) Air conditioning

Remove/install expansion valve

P83.30-3345-06

1 Cover

2 Expansion valve

3 Nut

4 Refrigerant line bracket

5 Screw

Remove/install

Danger!

Risk of explosion caused by welding or soldering work on closed air conditioning system. Risk of poisoning caused by inhaling overheated refrigerant vapors. Risk of injury to skin and eyes caused by contact with liquid refrigerant.

Never perform welding work on or near a closed air conditioning system. No smoking or open flames. Wear safety glasses and protective gloves. Work only in well ventilated areas. Carry out repair work on the air conditioning system circuit only after the system has been drained.

AS83.00-Z-0001-01A

1

Drain air conditioning system

Installation: Evacuate, refill and check air conditioner for leaks and proper operation. When filling the air conditioning system, add the amount of compressor oil that was extracted back to the refrigerant circuit. Use new compressor oil.

2

Move driver seat to its rearmost position

3

Remove cover (1) at expansion valve (2)

4

Remove nut (3) from bracket for refrigerant lines (4) at expansion valve (2)

*BA83.30-P-1001-01C

5

Pull refrigerant lines out of expansion valve (2).

6

Remove screws (5) from expansion valve (2)

Use care when removing screws (5) so that the line of the temperature switch is not kinked or otherwise damaged.

Installation: Install new seals at expansion valve (2).

*BA83.30-P-1016-01C

7

Remove expansion valve (2)

Installation: Replace O-rings and coat with refrigeration oil. Replace self-adhesive insulating mat at expansion valve (2).

8

Replace fluid reservoir

AR83.30-P-6520GM

9

Install in the reverse order

10

Turn on air conditioning and idle engine for about 4 minutes

For this, set the temperature switch and blower switch to maximum heat output.

11

Check air conditioning for proper operation

The air outlet temperature at the center air outlet should not undershoot
+5 °C.

12

Inspect the air conditioning circuit for leaks

Air conditioning system leak detector
gotis://E_83_04.0

Air conditioning

Number

Designation

Model
461

BA83.30-P-1001-01C

Nut on expansion valve

Nm

10

BA83.30-P-1016-01C

Expansion valve bolt

Nm

8

เอกสารที่อ้างถึง