S82.95-4510-08
1 | Nuts | N112/9 | HERMES control unit | |
2 | Electrical connectors |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Connect vehicle diagnosis system and commission HERMES control unit (N112/9). | If the HERMES control unit (N112/9) has been replaced. | |
| |||
2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
3 | Release the bottom trim for the instrument panel on the driver's side and remove it from the working area with attached electric lines. | ||
4 | Disconnect electrical connectors (2). | The number of electrical connections (2) may vary depending on vehicle equipment. | |
5 | Unscrew nuts (1). | ||
6 | Remove HERMES control unit (N112/9). | ||
7 | Install in the reverse order | ||
| Check | ||
8 | Run function test of emergency call system using vehicle diagnosis system. | ||
|