1 | Bolts |
2 | Screw |
3 | Rubber gaskets |
4 | Rubber seal |
5 | Suspension strut mount cover |
6 | Water repellent piece |
12 | Splash panel |
P82.30-2230-06
7 | Securing nuts |
8 | Securing nuts |
9 | Wiper motor connector |
10 | Knurled nut |
11 | Wiper system |
P82.30-2231-06
| Remove | ||
Danger | Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC. | No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers. | |
1 | Disconnect battery ground line | ||
Topical note | Notes on battery | ||
Warning | Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | |
2 | Remove wiper arms | ||
3 | Lift off rubber seals (3) on left and right from water deflector (6) | ||
4 | Lift rubber seal (4) off partition | Only in center area. | |
5 | Remove bolt (1) | ||
6 | Remove screw/bolt (2) | ||
7 | Move hood from vertical position to opening position | ||
8 | Unclip water deflector (6) from fold in windshield | The water deflector (6) is clipped into the lower area of the windshield across the entire length (arrows). | |
Mounting wedge | |||
9 | Remove water deflector (6) upward toward windshield from air/water duct | | |
Lift suspension strut mount cover (5) slightly. | |||
10 | Unscrew four nuts (7, 8) | | |
11 | Detach wiper motor connector coupling (9) | ||
12 | Remove windshield wiper system (11) | ||
| Install | ||
13 | Insert windshield wiper system (11) | ||
14 | Screw in three nuts (7) | Nut/bolt, wiper system to body | |
15 | Screw in nut (8) | Nut/bolt, wiper system to partition wall | |
16 | Connect wiper motor connector coupling (9) | ||
17 | Move wiper motor to parked position | ||
18 | Install water deflector (6) | Operation steps 9 to 3. | |
19 | Install wiper arms | ||
20 | Check operation of windshield wipers |
110 589 03 59 00
Mounting wedge