Wiper arm test and adjustment values
Number | Designation | Model | ||
BE82.30-P-1003-01I | Angle of incidence of wiper arm on driver-side in park position | Left-hand drive vehicle | ° | +2.5 to +6.5 |
Right-hand drive vehicle | ° | -2.5 to -6.5 | ||
BE82.30-P-1004-01I | Angle of incidence of wiper arm on front passenger side in park position | Left-hand drive vehicle | ° | +2.5 to +6.5 |
Right-hand drive vehicle | ° | -2.5 to -6.5 | ||
Adjustment tool set
211 589 02 21 00
P82.30-2306-04
The setting of the angle of incidence on the driver-side wiper arm and passenger-side wiper arm is always done in the park position and only when the check values differentiate from the tolerance range in the reversing or park and reversing position. In doing so, the driver-side wiper arm or passenger-side wiper arm is distorted by at least the value of the tolerance deviation in reversing position.
Use adjustment levers (Z4) from adjustment tool set.
P82.30-2477-11
1 Install angle gauge (A) with adapter on wiper arm to be adjusted.
2 Lower wiper arm until all three contact points of the base of the angle gauge (A) touch the windshield.
3 Put adjustment lever (Z4) as far apart as possible on this wiper arm.
The wiper arm is twisted with the aid of the adjustment lever (Z4), which was positioned close to the angle gauge (A). The second adjustment lever (Z4) is used as a counterholder.
4 Press the adjustment lever (Z4) into the required direction until the wiper arm is at least distorted by the value of the tolerance deviation in reversing position.
5 Remove adjustment lever (Z4) from wiper arm.
6 Read off angle of incidence for adjusted wiper arm on scale of angle gauge (A), write it down, and compare it to the corresponding test and adjustment value.
7 Detach angle gauge (A) with adapter from adjusted wiper arm.