S60.30-A026-09
1 | Additional brake lamp | 3 | Electrical line | 5 | Headliner | ||
2 | Vent windows | 4 | Electrical connector | 6 | Residual adhesive |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Open rear pop-out window (2). | ||
2 | Disconnect electrical connection (4). | To do so, pull down roof lining (5) far enough until electrical connector (4) is accessible. | |
3 | Guide electric line (3) out of slot (arrow) in roof lining (5). | ||
4 | Mask off area around additional brake lamp (1). | ||
5 | Mark installation position of additional brake lamp (1). | ||
6 | Remove additional brake lamp (1) from pop-out window (2). | To do so, place a suitable cutting tool between additional brake lamp (1) and pop-out window (2) and make a separating cut. | |
Installation: Use new additional brake lamp (1). | |||
| Clean | ||
7 | Remove residual adhesive (6). | Cleaner | |
8 | Install in the reverse order. | ||
| Check | ||
9 | Perform function test on additional brake lamp (1). |