Remove/install rear lamp unit

AR82.10-S-4731P

Remove/install rear lamp unit

26.07.2017

Model

470, 471

Shown on left side of vehicle

1

Mounting clip

2

Nut

3

Electrical connector

E3

Left rear lamp unit

E4

Right rear lamp unit

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 

Remove/install

1

Switch off exterior lighting and turn signal lights

2

Switch off ignition and store transmitter key outside of transmission range (min. 2 m)

3

Remove retaining clip (1)

 Clip remover

*452589016300

4

Unscrew nuts (2)

5

Take lamp unit (E3, E4) out of dropside far enough to access electrical connector (3)


Handle lamp unit (E3, E4) with care.
Otherwise damage may occur to the vehicle paint and/or to the lamp unit (E3, E4).

6

Disconnect electrical connector (3) and remove lamp unit (E3, E4)

7

Install in the reverse order



Check

8

Perform function check of lamp units (E3, E4)



AP82.10-S-8251P