Shown on model 907 |
1 | Level sensor |
2 | Nut |
3 | Screw |
4 | Electrical connector |
D82.10-1219-06
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Perform commissioning of headlamp control unit using vehicle diagnosis system | When replacing level sensor (1). | |
| |||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
2 | Raise vehicle | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
3 | Unscrew nut (2), remove relevant bolt disassemble linkage from level sensor (1) | ||
Topical note | Notes on self-locking nuts and bolts | ||
Bolt/nut, linkage to level sensor | |||
4 | Remove bolts (3) and remove level sensor (1) from holder | Bolt, level sensor to bracket | |
5 | Disconnect electrical connector (4) and remove level sensor (1) | ||
6 | Install in the reverse order | ||
| Check | ||
7 | Check/correct position of headlamps | After replacing level sensor (1). | |