Adjusting gap between vario-roof and cross member above windshield

AR77.50-P-3035G

Adjusting gap between vario-roof and cross member above windshield

28.5.10

Adjustment

1

Check gap with feeler gauge



 A V-shaped gap of 1 mm is permissible over the width of the roof.

*129589032100

2

Remove paneling at top of windshield

AR68.30-P-4250G

3

Loosen screws (2) and remove intermediate layer (3) or insert depending on gap dimension

 Then tighten screws (2) only slightly.

4

Close vario-roof and align vario-roof laterally in relation to cross member above windshield and A-pillar (direction of arrow)

 Adjust vario-roof in relation to cross member above windshield so that it is flush to 1 mm lower.

5

Open and close vario-roof

 When closing the rotary catch should engage in the center of the mount and should not touch the mount (1) at the top or bottom 

 Check adjustment of catch on C-pillar 

AR77.50-P-3045G

 Check adjustment of vario-roof contour

AR77.50-P-3040G

6

Tighten screws (2)

*BA77.33-P-1002-01A

7

Install paneling at top of windshield

AR68.30-P-4250G

Number

Designation

Model
170

BA77.33-P-1002-01A

Screws for mount on cross member above windshield

Nm

10