129 589 03 21 00
Feeler gauge
P77.21-2601-09
1 | Place panoramic sliding sunroof frame (1) onto suitable base with inside pointing upward. |
2 | Cut down residual adhesive beads (2) on panoramic sliding sunroof frame (1) to a remaining height of approx. 1 to 2 mm using a scraper. |
If the panoramic sliding sunroof frame (1) is to be reused. |
3 | Remove residues of spacers (3) completely. |
If the panoramic sliding sunroof frame (1) is to be reused. |
4 | Clean panoramic sliding sunroof frame (1). |
If the panoramic sliding sunroof frame (1) is to be reused. |
Commercially available devices/tools |
5 | Clean bonding surfaces on panoramic sliding roof frame (1). |
The cleaner is included in the repair kit. |
Apply cleaner only to bonding surfaces and allow to dry completely. |
It is not necessary to prime the bonding surfaces. |
6 | Install new spacers (3) as shown. |
7 | Place panoramic sliding sunroof frame (1) onto body and use the feeler gauge to align the distance between the top edge of the window and the roof front edge/sliding roof frame . |
Two helpers required. |
Center panoramic sliding sunroof frame (1) between side roof panelings and windshield. |
8 | Affix the strips of adhesive tape and cut through at the outer edges of the panoramic sliding sunroof frame (1). |
9 | Place panoramic sliding sunroof frame (1) onto suitable base with inside pointing upward. |
10 | Apply activator to bonding surfaces on panoramic sliding roof frame (1). |
The activator is included in the repair kit. |