P77.21-2589-08
1 | Sliding roof cover | 2 | Bolts |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Raise sliding roof panel (1) to tilt position and open until screws (2) can be accessed. | ||
2 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
3 | Unscrew bolts (2). | ||
4 | Remove sliding roof panel (1) upwards and set down on a suitable base. | Helper required. | |
5 | Install in the reverse order. | ||
Adjust | |||
6 | Adjust sliding roof panel (1). |