P68.80-2128-09
1 | Load compartment floor | 2 | Bolts |
1 | Load compartment floor |
3 | Screw |
P68.80-A002-05
Danger | Risk of explosion caused by escaping hydrogen or overheating of the fuel tanks when working on the hydrogen system. Risk of frostbite to body parts caused by escaping gas and by touching component parts carrying gas when emptying fuel tanks. Risk of asphyxiation caused by inhalation of air diluted by hydrogen. Risk of burn injuries by coming into contact with an invisible pale blue hydrogen flame. | ||
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Topical note | Notes on fuel cell system | ||
Notes on HANDS-FREE ACCESS | |||
| Remove/install | ||
1 | Ensure that the prerequisites for driving into the workshop are fulfilled. | ||
Topical note | Requirements for driving into the workshop | ||
2 | Print out the "Protokoll Tanksystem, Formular" (tank system event log form), fill it out, and attach to the vehicle in a place where it is easily visible. | ||
| |||
3 | Remove load compartment cover. | If installed. | |
4 | Fold rear seats forward. | ||
5 | Fold up rear section of load compartment floor (1). | ||
6 | Unscrew bolts (2). | Screws (2) are located behind lugs of load compartment well cover. | |
Model 253.992/993 | |||
7 | Fold load compartment floor (1) forward. | ||
8 | Remove screw/bolts (3). | ||
9 | Remove load compartment floor (1). | ||
10 | Install in the reverse order. |