Remove/install handle on roof

AR68.30-S-4330S

Remove/install handle on roof

06.12.2019

Model

636, 639

1

Caps

2

Bolts

3

Grab handle

Vehicles with code LD5 (additional interior lamp in the passenger compartment) /code VP3 (AMBIENTE equipment line)

3

Grab handle

6

Electrical connector

 

Remove/install

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

1

Switch off the ignition and remove the transmitter key from the EIS control unit

Only with model 639.603/703 with engine 780.994 with code MA0 (E-CELL 60 kW)


Do not begin working on electrical or electronic components earlier than 1 min after switching off the ignition.
Otherwise faults could occur in the battery management system.

2

Fold up the covers (1)

3

Remove screw/bolts (2)

4

Remove the grab handle (3)

 Installation: Make sure that the grab handle (3) is correctly seated.

5

Disconnect the electrical connector (6) on the grab handle (3)

Only with code LD5 (additional interior lamp in the passenger compartment), with code VP3 (AMBIENTE equipment line)

6

Install in the reverse order



Check

7

Check the function of the interior light in the grab handle (3)

Only with code LD5 (additional interior lamp in the passenger compartment), with code VP3 (AMBIENTE equipment line)