Remove/install paneling on rear center section

AR68.30-P-4785LWS

Remove/install paneling on rear center section

25.04.2019

Model

205.2

Model

253

Model

293

Shown on model 205.2 (except 205.213/247/253/293)

1

Rear center section paneling

2

Load compartment floor rear section

3

Screw

4

Frame seal

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Notes on HANDS-FREE ACCESS

AH80.61-P-0001-01A

 

Remove/install

1.1

Remove load compartment floor rear section (2).

Model 205.2 (except 205.247)
Model 253.9 (except 253.954)
Model 293

1.2

Fold over load compartment floor rear section (2).

Model 205.247
Model 253.3/954

2.1

Remove load compartment well trim.

Model 205.247

2.2

Remove rear retaining clips of the load compartment well trim.

Model 205.213/253

2.3

Remove screw (3).

Model 205.2 (except 205.213/247/253)
Model 253
Model 293

3

Unclip rear-end center section trim (1) and remove.


Model 205.213/253
Carefully press load compartment well trim to the side.
Otherwise it may be damaged.

 Model 205.213/253
Installation: The load compartment well trim must lie on the right and left side over the rear-end center section trim (1).

 Installation: Ensure sealing frame (4) is correctly seated.

 Long wedge

*115589035900

4

Install in the reverse order