Shown on right side of vehicle, with CODE 810 (Sound system) and CODE 890 (EASY-PACK liftgate) |
1 | D-pillar paneling |
2 | Cargo area side paneling |
3 | Edge guard |
4 | Electrical connector (with CODE 890 (EASY-PACK liftgate)) |
5 | Bolts |
6 | Roller blind guide |
7 | Electrical connector |
8 | Mounting clamp |
P68.30-3824-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Notes on sensor system for trunk lid opening/closing | ||
| Remove/install | ||
1 | Detach left and right cargo area side paneling (2) in rear area until bolts (5) are accessible | ||
2 | Detach edge guard (3) in area of D-pillar paneling (1) | ||
3 | Disconnect electrical connection (4) | MODEL 205.2 | |
4 | Remove screws (5) | ||
5 | Move roller blind guide (6) out of D-pillar paneling (1) in direction of arrow and remove | ||
6 | Unclip D-pillar paneling (1) in rear area as shown | ||
7 | Disconnect electrical connector (7) | ||
8 | Carefully unclip D-pillar paneling (1) and remove | Installation: Ensure that mounting clips (8) are seated correctly. | |
9 | Install in the reverse order |