Shown with code 876 (Interior Light Package) |
1 | Screw |
2 | Cover |
3 | Electrical connector |
4 | Electrical connector |
5 | Electrical connector |
6 | Electrical connector |
7 | Engine hood release handle |
P68.10-A026-06
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Move driver's seat to rearmost end position. | ||
2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
3 | Remove screws (1). | ||
4 | Lower trim (2) (arrows B) until the electrical connectors (3, 4, 5, 6) are accessible. | The number can vary according to the equipment. | |
5 | Disconnect electrical connectors (3, 4, 5, 6). | The number can vary according to the equipment. | |
6 | Release engine hood release handle (7) and remove toward the rear from the trim (2). | ||
7 | Unhook trim (2) at the rear from the floor covering and remove. | ||
8 | Install in the reverse order. |