1 | Rear pop-out window |
2 | Retainer |
3 | Gas-filled strut |
S60.30-0335-04
S60.30-0336-08
4 | Nuts | 5 | Electrical connector |
S60.30-0337-09
Shown on left lock (6) |
6 | Lock | 8 | Lock striker | a | Dimension (approx. 2 mm) | ||
7 | Lock striker bracket | 9 | Bolts | b | Dimension (approx. 2 mm) |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Warning | Risk of injury from fingers being pinched or jammed when working on gas struts under pressure | Only remove and install pneumatic springs when they are not under tension and when the components are properly secured. | |
| Remove/install | ||
1 | Open the rear pop-out window (1). | ||
2 | Remove pneumatic springs (3) from rear pop-out window (1). | To do so, pry off the respective retainer (2) with a suitable tool. | |
Secure the rear pop-out window (1) against falling down. | |||
3 | Disconnect electrical connectors (5). | To do this, remove the roof lining of the hardtop in the installation area of the electrical connectors (5) to the extent that the electrical connectors (5) are accessible. | |
4 | Remove rear pop-out window (1). | To do so, unscrew nuts (4). | |
Nut, rear hinge to pop-out window on hardtop | |||
5 | Install in the reverse order. | ||
Adjust | |||
6 | Adjust rear pop-out window (1). | If required. | |
To do this, loosen the screws (9) until the respective lock striker (8) can be moved. | |||
Maintain the dimensions (a, b) between the respective bracket lock striker (7) and lock (6). | |||
Bolt, lock striker to rear pop-out window on hardtop | |||
| Check | ||
7 | Perform function test of the electric component parts of the rear pop-out window (1). |