Shown on left side of vehicle |
1 | Multipiece A-pillar |
2 | Inner A-pillar |
3 | Reinforcement |
4 | Mounting support for engine hood hinge |
S63.20-4932-06
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Special instructions for lifting and supporting vehicle | ||
Topical note | General information on body repair | ||
General information on MB materials | |||
| Remove | ||
1 | Remove all detachable parts in area to be repaired | ||
2 | Cover all detachable parts remaining in vehicle with fire-resistant welding protection blanket | Commercially available devices/tools | |
3 | Remove multipiece A-pillar (1) and mounting support for hood hinge (4) | ||
4 | Remove inner A-pillar (2) and reinforcement (3) | ||
Commercially available devices/tools | |||
Zinc dust paint suitable for spot welding | |||
5 | Prepare inner A-pillar (2) and reinforcement (3) | ||
Commercially available devices/tools | |||
Zinc dust paint suitable for spot welding | |||
| Install | ||
Danger | The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases | Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system. | |
6 | Install inner A-pillar (2) and reinforcement (3) | ||
Topical note | Measures for preventing damage to components when performing electric welding and soldering work | ||
| 000 588 01 84 00 Welder | ||
| 000 588 02 84 00 Welder | ||
Commercially available devices/tools | |||
Zinc dust paint suitable for spot welding | |||
Side portal frame | |||
7 | Install multipiece A-pillar (1) and mounting support for hood hinge (4) | ||
8 | Remove welding protection blankets | Commercially available devices/tools | |
9 | Install all detachable body components in area to be repaired |
210 589 17 23 00
Side portal frame