P61.00-2061-09
Shown without wheels for a better overview |
1 | Rear axle underfloor paneling | 6 | Rear right underfloor paneling | |
2 | Transmission tunnel underfloor paneling | 7 | Underfloor paneling, right | |
3 | Center left underfloor paneling | 8 | Underfloor paneling, left | |
4 | Center right underfloor paneling | 9 | Rear end underfloor paneling | |
5 | Underfloor paneling in front of rear axle |
Shown without wheels for a better overview |
10 | Expansion rivet |
11 | Nut |
P61.30-A001-12
24 | Retaining clamps |
P61.30-A000-05
Shown without center right underfloor paneling |
25 | Electrical connector |
H4/16 | Sound generator |
P06.20-2042-12
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on fuel cell system | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Ensure that the prerequisites for driving into the workshop are fulfilled. | ||
Topical note | Requirements for driving into the workshop | ||
2 | Print out the "Protokoll Tanksystem, Formular" (tank system event log form), fill it out, and attach to the vehicle in a place where it is easily visible. | ||
| |||
3 | Lift vehicle with lifting platform. | ||
4 | Remove center engine compartment lining. | ||
5 | Remove rear axle underfloor paneling (1). | Carefully remove rear axle underfloor paneling (1) until the retaining clamps (24) of the exhaust air pipe are accessible. | |
6 | Detach retaining clamps (24) from the exhaust air pipe. | ||
7 | Remove transmission tunnel underfloor paneling (2). | ||
8 | Remove center left underfloor paneling (3). | ||
9 | Release center right underfloor paneling (4) until the electrical connector (25) is accessible. | ||
10 | Disconnect electrical connector (25) and remove center right underfloor paneling (4) with sound generator (H4/16). | ||
11 | Remove underfloor paneling in front of rear axle (5). | Clip remover | |
12 | Remove rear right underfloor paneling (6). | Clip remover | |
13 | Remove and unscrew expansion rivets (10) and nut (11) of the right and left fender interior trim. | Clip remover | |
14 | Remove right underfloor paneling (7). | Clip remover | |
15 | Remove left underfloor paneling (8). | Clip remover | |
16 | Remove rear end underfloor paneling (9). | Clip remover | |
17 | Change sound generator (H4/16). | When installing new center right underfloor paneling (4). | |
18 | Install in the reverse order. |
452 589 01 63 00
Clip remover