P61.20-2056-11
Shown on vehicle with code (I60) Stationary heater, gasoline
1 Engine compartment lining
2 Profile rubber element (on vehicles with code (I58) Stationary heater, diesel or code (I60) Stationary heater, gasoline )
3 Exhaust line (on vehicles with code (I58) Stationary heater, diesel or code (I60) Stationary heater, gasoline )
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | |
1 | Raise vehicle | ||
2.1 | Press profile rubber element (2) with exhaust line (3) upward through hole into engine compartment paneling (1) | Only on vehicles with code (I58) Stationary heater, diesel or code (I60) Stationary heater, gasoline | |
Installation: Ensure that profile rubber element (2) is seated correctly in engine compartment paneling (1). | |||
3 | Remove clips from engine compartment paneling (1). | ||
4 | Pull out engine compartment paneling (1) toward rear | ||
5 | Install in the reverse order |