Test values for frame floor
Number | Designation | Model 903, 904 with code ZG1 or code ZG2 or code ZG3 | |
BE61.10-N-1001-02A | Incline angle of shock-absorber strut mount | | 6° 30' (1°) |
Protractor (electronic)
001 589 88 21 00
Workshop equipment
WE58.40-Z-1013-01B | Pulling device for incline angle at the damper strut support for all-wheel drive Sprinter WBM 0337.01, Firma Wilhelm Oberaigner GmbH, A-04150 Rohrbach (Austria) |
WE58.40-Z-1014-01B | Blackhawk 4t Standard pulling set 65477 |
D61.10-1117-01
1 Adjust stop disk (5) of puller (01) to basic dimension a=33 mm.
D61.10-1112-01
2 Mount pullers (01) on the shock absorber strut mounts.
D61.10-1113-10
3 Mount hydraulic pull ram (02) on the pullers (01).
D61.10-1114-01
4 Compress pullers (01) together until the stops (5) bear against the longitudinal frame member. Release tension on puller.
5 Tighten nut (6) on pullers and repeat preceding step 2-3 times.
6 Release tension on pull ram (02).
D61.10-1155-01
7 Attach protractor (03) to frame longitudinal member (7) at height of shock absorber strut mount and calibrate protractor to "0" at calibration knob (8).
For further information on calibration see equipment operating instructions.
D61.10-1156-01
8 Attach protractor (03) to puller (01) at outside and read inclination angle off of shock absorber strut mount.
If the value to be set has not yet been reached, shift the stops (5) slightly and repeat steps 4 through 8.
9 Remove pull ram (02) and pullers (01).