AR60.80-W-1100G | Remove/install cab tilt cylinder | 16.9.04 |
MODEL 375.4 with BODY 375.860
MODEL 374.6, 940.1 /2 /3, 942.1 /3, 943.1 /3, 944.0 /1 /2 with BODY 944.890
MODEL 958.4 with BODY 958.880
W60.80-1116-06
1 Bolt
2 Pin
3 Cab tilt cylinder
4 Hydraulic line
5 Hydraulic line
6 Cotter pin
7 Washer
| Remove/install | ||
Danger! | Risk of injury caused by being caught or pinched as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
2 | Attach fastening strap to cab | ||
| |||
3 | Remove bolt (2) from cab tilt cylinder (3) | The cab tilt cylinder (3) should be free of tension | |
4 | Fasten position of cab tilt cylinder (3) | ||
5 | Retract cab tilting cylinder (3) | Installation: Open filler screw on manual pump and completely extend/retract cab tilt cylinder (3). The hydraulic system is vented by extending/retracting the cab tilt cylinder (3). Observe oil level of manual pump | |
6 | Mark hydraulic lines (4, 5) and remove | ||
7 | Remove cab tilt cylinder (3) | Installation: Use new cotter pin (6). | |
8 | Install in the reverse order | ||
| Check | ||
9 | Check oil level in hydraulic tilting pump | ||
10 | Check connections for leakage |
Cable harness
970 589 00 31 00