AR60.80-W-1100F | Remove/install cab tilt cylinder | 15.9.04 |
MODEL 375.3 with BODY 375.820
MODEL 950.5 /6, 952.5 /6, 953.6, 954.5 with BODY 940.890
MODEL 958.2 with BODY 958.870
W60.80-1004-06
Shown on body 940.890
1 Cab tilt cylinder
2 Pin
3 Bolt
4 Vinyl ring
5 Suspension on cab mount
6 Bushing
7 Journal
8 Cotter pin
9 Hydraulic line
10 Hydraulic line
11 Washer
12 Washer
| Remove/install | ||
Danger! | Risk of injury caused by being caught or pinched as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
2 | Attach fastening strap to cab | ||
| |||
3 | Remove bolt (2) from cab tilt cylinder (1) | The cab tilt cylinder (1) should be free of tension | |
4 | Pivot cab tilt cylinder (1) toward rear and remove vinyl rings (4) and bushing (6) | ||
5 | Retract cab tilting cylinder (1) | Installation: Open filler screw on manual pump and completely extend/retract cab tilt cylinder (1).The hydraulic system is vented by extending/retracting the cab tilt cylinder (1). | |
6 | Mark hydraulic lines (9, 10) and remove | Catch oil running out in suitable vessel | |
7 | Remove cab tilt cylinder (1) | Installation: Use new cotter pin (8). | |
8 | Install in the reverse order | ||
| Check | ||
9 | Check oil level in hydraulic tilting pump | ||
10 | Check connections for leakage |
Cable harness
970 589 00 31 00