1 | Mounting clip |
2 | Cover |
3 | Handle |
4 | Nuts |
S60.30-A009-06
Shown on left side of vehicle |
6 | Electrical connector |
7 | Lock |
8 | Control cable guide |
9 | Catch hook |
10 | Cable |
11 | Bolts |
S60.30-A072-06
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Open rear pop-out window. | ||
2 | Remove handle (3). | To do so, remove nuts (4). | |
Removal: Mark installation position of handle (3). | |||
Installation: Observe marking of the installation position of the handle (3). | |||
Nut, handle to rear pop-out window to hardtop | |||
3 | Remove cover (2). | To do so, remove retaining clips (1). | |
4 | Disconnect electrical connection (6). | ||
5 | Unclip respective cable guide (8) from the respective catch hook (9). | ||
6 | Unhook respective cable (10). | ||
7 | Remove respective lock (7). | To do this, remove screw/bolts (11). | |
Screw, lock on rear pop-out window to hardtop | |||
8 | Install in the reverse order. | ||
| Check | ||
9 | Check function of the lock (7). |