S60.30-0238-09
1 | Platform tarp | 10 | Locks | 11 | Cable |
8 | Cross struts |
S60.30-0237-06
S60.30-0236-09
Shown on left side of vehicle |
1 | Platform tarp | 12 | Side dropside | |
2 | Left guide rail | a | Dimension (approx. 300 mm) | |
7 | Fastening clamps | b | Dimension (approx. 530 mm) | |
9 | Bolts |
1 | Platform tarp |
4 | Support straps |
5 | Shims |
6 | Bolts |
S60.30-0235-06
| Remove/install | ||
1 | Remove antenna rod. | ||
2 | Open rear dropside. | ||
3 | Open platform tarp (1). | For this purpose, press platform tarp (1) in center slightly downwards and at the same time release platform tarp (1) with cable (11). | |
Installation: Insert platform tarp (1) at sides, as shown in figure A, into left guide rail (2) and right guide rail. | |||
Silikonspray Silikon-Fluid, 0.4 l art. no. 0893 221 000 | |||
4 | Pull platform tarp (1) fully forwards and carefully set down on roof. | Helper required. | |
5 | Remove cross struts (8). | Note installation position of cross struts (8). | |
6 | Remove fastening clamps (7). | For this purpose, release screws (9). | |
Note installation position of fastening clamps (7). | |||
Installation: Observe dimensions (A, B). | |||
Bolt, mounting clamp for tarpaulin to dropside at side | |||
7 | Remove right guide rail and left guide rail (2). | Installation: Right guide rail and left guide rail (2) must be fully in contact with the platform tarp (1) and be, as shown (arrow), flush with the side dropside (12). | |
8 | Remove platform tarp (1) with grab straps (4). | For this purpose, remove screws (6) with washers (5). | |
Bolt, tarpaulin rail on front dropside | |||
| Clean | ||
9 | Clean contact surfaces in installation area of platform tarp (1). | Cleaner | |
10 | Install in the reverse order | ||
| Check | ||
11 | Check function of platform tarp (1). |
Repair materials |
Number | Designation | Order number |
BR00.45-Z-1025-04A | Cleaner | A 005 989 19 71 |
BR00.45-Z-1133-06A | Silikonspray Silikon-Fluid, 0.4 l art. no. 0893 221 000 | Adolf Würth GmbH & Co. KG |