S60.30-0040-09
Shown with code FR8 (reversing camera) |
1 | Handle | 3 | Linkage rod | 5 | Electrical connector (with code FR8 (reversing camera) or with code JS1 (360° camera)) | ||
2 | Locks | 4 | Bolts |
Shown with code FR8 (reversing camera) |
1 | Handle |
6 | Lock |
7 | Linkage rod |
8 | Lock cylinder |
10 | Camera (with code FR8 (reversing camera) or with code JS1 (360° camera)) |
11 | Screws (with code FR8 (reversing camera) or with code JS1 (360° camera)) |
S60.30-0041-06
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Remove existing detachable parts | Depending on the equipment variant and/or installed body, detachable parts may be available in addition. | |
2 | Remove inner cover on dropside | ||
3 | Remove linkage (3) from handle (1) | To do so, release the locks (2). | |
4 | Disconnect electrical connection (5) | Model 470, 471 | |
5 | Remove handle (1) | For this purpose, remove bolts (4). | |
6 | Remove linkage (7) from handle (1) | When replacing handle (1). | |
To do so, release lock (6). | |||
7 | Remove lock cylinder (8) | When replacing handle (1). | |
Do not remove linkage (7) from lock cylinder (8). | |||
8 | Remove camera (10) with bracket | Model 470, 471 | |
To do this, remove screw/bolts (11). | |||
9 | Install in the reverse order | ||
10 | Calibrate camera (10) | Model 470, 471 | |
| |||
| Check | ||
11 | Check function of handle (1) | ||
12 | Perform function check of camera (10) | Model 470, 471 |