S60.30-0036-09
1 | Lock left | 4 | Check straps | 7 | Lock | ||
2 | Lock right | 5 | Linkage rod | 8 | Linkage rod | ||
3 | Screw | 6 | Lock | 9 | Handle |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Remove existing detachable parts | Depending on the equipment variant or the installed body, there may be additional detachable parts. | |
2 | Remove inside cover on dropside | ||
3 | Remove respective linkage (5, 8) from handle (9) | To do so, release lock (6) on linkage (5) or lock (7) on linkage (8). | |
4 | Remove left lock (1) with linkage (5) in direction of arrow | When removing the left lock (1). | |
To do so, remove screws (3) from left lock (1). | |||
Installation: Observe installation position of check strap (4) on left lock (1). | |||
Screw, lock to dropside | |||
5 | Remove right lock (2) with linkage (8) in direction of arrow | When removing the right lock (2). | |
To do so, remove screws (3) from right lock (2). | |||
Installation: Observe installation position of check strap (4) on right lock (2). | |||
Screw, lock to dropside | |||
6 | Modify the linkage (5) | When replacing the left lock (1). | |
7 | Modify the linkage (8) | When replacing the right lock (2). | |
8 | Install in the reverse order |