S54.65-4701-08
Shown on model 470 with code FR8 (Reversing camera) |
1 | Electrical connector | 3 | Backup camera | 5 | Electrical connector | ||
2 | Screw |
Shown on model 470 with code FR8 (Reversing camera) |
3 | Backup camera |
4 | Bracket |
S54.65-4695-04
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Read out and temporarily store basic data from reversing camera (3). | If the reversing camera (3) is to be replaced. | |
Installation: Transfer buffered basic data and perform initial startup of reversing camera (3). | |||
2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
3 | Remove inner cover from rear dropside. | ||
4 | Disconnect electrical connector (1). | ||
5 | Disconnect electrical connector (5). | Model 470, 471 | |
6 | Unscrew screws (2) and take reversing camera (3) out of rear dropside. | ||
7 | Unclip reversing camera (3) from holder (4) (arrows) and remove holder (4). | If the reversing camera (3) is to be replaced. | |
8 | Install in the reverse order | ||
9 | Calibrate reversing camera (3). | ||
| |||
| Check | ||
10 | Perform function check of reversing camera (3). |