Prepare USB data medium | |||
1 | In VeDoc determine the so-called Diogenes name of the affected control unit and note it down | The Diogenes name can be found in VeDoc in the column of the same name under the "Control units" tab. | |
2 | Copy the two files of type "exf" and "cff" into the root folder or top level of a USB data medium | | |
The workshops usually receive these files as TIPS attachments or as e-mail attachments from the support department. | |||
3 | In the same folder, or at the same level, create a folder with the Diogenes name for the control unit noted beforehand | | |
4 | Move the cff file into this folder | ||
Change software release | |||
5 | Connect XENTRY Connect and XENTRY Tab, launch XENTRY from XENTRY Tab and switch on the ignition | ||
6 | Perform initial quick test | The initial quick test is stored until the end of the diagnosis session. | |
7 | Connect USB data medium to XENTRY Tab | ||
8 | Select "Control unit programming" for the exhaust aftertreatment control unit (ACM) | ACM - Exhaust aftertreatment (A60) | |
9 | When asked whether the process is to be performed online or offline, answer "Offline" | ||
10 | In the next window, select the exf file displayed under "Available data versions" and confirm with "Continue" | ||
11 | In the next window, confirm the displayed "New software version" with "Programming" | ||
12 | In the next window, confirm the displayed information with "Continue" | ||
13 | In the next window, confirm the displayed information with "Offline" | ||
14 | In the next window, enter the encrypted random number from VeDoc and confirm with "Continue" | This launches the actual programming sequence. | |
15 | In the next window, confirm the displayed information with "Continue" | ||
Redocumentation of vehicle data record to VeDoc | |||
16 | Redocument vehicle data records to VeDoc | Special functions | |
17 | Run final quick test, print out initial quick test and final quick test and file them | There must be no fault codes in the control units being updated. If necessary, process any fault codes in other control units, subject to a separate repair order. | |
18 | Exit XENTRY and disconnect XENTRY Connect and XENTRY Tab |