Model | 172.4 |
with code 513 (Speed Limit Assist) | |
Model | 172.4 |
with code 608 (Adaptive Highbeam Assist) | |
Model | 204, 216, 221 |
with code 238 (Active lane keeping Assist) | |
Model | 204, 216, 221 |
with code 476 (Lane keeping assist) | |
Model | 204, 216, 221 |
with code 513 (Speed Limit Assist) | |
Model | 204, 216, 221 |
with code 608 (Adaptive Highbeam Assist) | |
Model | 207, 212, 218 |
with code 22P (Lane tracking package) | |
Model | 207, 212, 218 |
with code 23P (Driving Assistance package) | |
Model | 207, 212, 218 |
with code 476 (Lane keeping assist) | |
Model | 207, 212, 218 |
with code 513 (Speed Limit Assist) | |
Model | 207, 212, 218 |
with code 608 (Adaptive Highbeam Assist) | |
Model | 207, 212, 218 |
with code 628 (Adaptive Highbeam Assist Plus) |
Shown on model 212 |
1 | Cover |
2 | Electrical connector |
3 | Catch hook |
4 | Bracket |
5 | Multifunction camera |
P54.21-3040-04
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Switch off ignition | ||
2.1 | Unclip and remove cover (1) | Model 172.4, 204, 212, 218, 221 model 207.3, 216 up to model year 2011 | |
2.2 | Slide cover (1) all way forward and remove | Model 207.4, 216 as of model year 2011 | |
3 | Remove splinter protection | Model 212 with code Z04 (Light armoring) | |
Nut/bolt, splinter guard to rain/light sensor guard plate | |||
4 | Position assembly wedge between holder (4) and multifunction camera (5) and release catch hooks (3) | Mounting wedge | |
5 | Guide multifunction camera (5) out of rear brackets in direction of arrow | | |
6 | Disconnect electrical connectors (2) and remove multifunction camera (5) | ||
7 | Install in the reverse order | ||
8 | Calibrate multifunction camera (5) using diagnostic system | ||
| 000 588 11 21 00 Adjustment device | ||
| 000 588 00 23 00 Adjusting gauge | ||
|
110 589 03 59 00
Mounting wedge