P54.10-3474-09
Shown on model 207.4 |
1 | Luggage compartment floor covering | 5 | Ground cable | 9 | Vent hose | ||
2 | Spare tire well paneling | 6 | Cover | 10 | Nut | ||
3 | Support brace | 7 | Positive line | 11 | Bow | ||
4 | Screw | 8 | Screw | G1/13 | ECO start/stop function additional battery |
| Remove/install | ||
Danger | Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC. | No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers. | |
Topical note | Notes on battery | ||
1 | Switch off all electrical consumers, switch off ignition and remove transmitter key from electronic ignition lock control unit | | |
2 | Open luggage compartment floor cover (1) | ||
3 | Detach spare wheel well trim (2) far enough until the additional battery for the ECO start/stop function (G113) is accessible | ||
4 | Remove support (3) | ||
5 | Remove bolt (4) and detach ground line (5) from additional battery for ECO start/stop function (G1/13) | Screw/bolt, battery cable to battery terminal on additional battery | |
6 | Remove cover (6) of positive line (7) | ||
7 | Use diode test lamp to check the on-board electrical system for voltage between the positive line (7) and a suitable ground point | | |
If the diode test lamp lights up, the on-board electrical system is still active because of a defect in the electrical system. | |||
| |||
In this case the ground line of the on-board electrical system battery should be disconnected. | |||
The electrical system is to be repaired once the work to be carried out has been completed. | |||
8 | Unscrew bolt (8) and remove positive line (7) | Screw/bolt, battery cable to battery terminal on additional battery | |
9 | Unscrew nut (10) of bracket (11) | ||
10 | Swivel bracket (11) upwards | ||
11 | Detach vent hose (9) from ECO start/stop function additional battery (G1/13) | Installation: | |
12 | Remove additional battery for ECO start/stop function (G1/13) from battery holder | ||
13 | Install in the reverse order |