P49.10-3199-09
1 | Gasoline particulate filter | 3 | Clip | 5 | Screw | ||
2 | Clip | 4 | Clip | 6 | Elastomer bearing |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Warning | Risk of burn injuries, suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area. | |
Topical note | Notes on self-locking nuts and bolts | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Remove lower rear and center engine compartment lining. | ||
Installation: Only install center and rear lower rear engine compartment paneling again after leak test. | |||
2 | Remove clamps (2, 3). | Installation: Replace clamps (2, 3). | |
Clamp, gasoline particulate filter/center exhaust system connecting point to rear exhaust system | |||
3 | Support gasoline particulate filter (1). | ||
| 000 588 10 62 00 Support plate | ||
| 000 588 11 62 00 Major assembly mount | ||
4 | Remove clamp (4). | Installation: Replace clamp (4). | |
Clamp, gasoline particulate filter/center exhaust system connecting point to catalytic converter | |||
5 | Remove screw (5). | Holder, decoupling element/gasoline particulate filter/center exhaust system | |
6 | Remove elastomer bearings (6) from gasoline particulate filter (1). | Installation: Wet elastomer bearings (6) with lubricant. | |
Lubricant, rubber assembly 1 l | |||
7 | Remove gasoline particulate filter (1). | ||
| 000 588 10 62 00 Support plate | ||
| 000 588 11 62 00 Major assembly mount | ||
Helper required. | |||
| Check | ||
8 | Check the elastomer bearings (6) and decoupling element for damage and wear and replace if necessary. | Holder, decoupling element/gasoline particulate filter/center exhaust system | |
| Clean | ||
9 | Remove combustion and corrosion residue at connecting points. | ||
10 | Install in the reverse order. | ||
11 | Check installation position and unobstructed movement of exhaust system and correct if necessary. | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
12 | Perform engine test run and check exhaust system in terms of leak tightness. | ||
13 | Install rear lower and center engine compartment lining. |