P49.10-3294-08
Shown on model 205.4 |
1 | Rear muffler | 4 | Diagonal strut | |
2 | Cover | 5 | Clip | |
3 | Underfloor paneling | 6 | Elastomer bearing |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Warning | Risk of burn injuries, suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area. | |
Topical note | Notes on self-locking nuts and bolts | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
1 | Raise vehicle. | ||
2 | Remove cover (2). | Engine 654 in model 205.4 | |
3 | Remove left underfloor paneling (3). | Engine 654 in model 205.4 | |
4 | Remove diagonal strut (4). | Engine 654 in model 205.4 | |
Bolt, rear diagonal strut to spare wheel well/body | |||
5 | Secure rear muffler (1) against falling down. | ||
| 000 588 11 62 00 Major assembly mount | ||
| 000 588 10 62 00 Support plate | ||
6 | Open clamp (5). | Installation: Replace the clamp (5). | |
Clamp, connecting point for front of exhaust system to rear of exhaust system | |||
7 | Disconnect rear muffler (1) from elastomer bearings (6) and remove. | Installation: Wet elastomer bearings(6) with lubricant. | |
Lubricant, rubber assembly 1 l | |||
| Clean | ||
8 | Remove combustion and corrosion residue at connecting points. | ||
| Check | ||
9 | Check elastomer bearings (6) for wear and damage. | If complaints are present, | |
| |||
Replace the elastomer bearings(6). | |||
10 | Install in the reverse order. | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
11 | Perform engine test run and check exhaust system in terms of leak tightness. |