P20.10-2559-09
Shown on model 177 |
1 | Purge line | 2 | Separation point | 3 | Coolant line |
P43.05-2130-09
Shown on model 177 |
3 | Coolant line | 7 | Connection | 10 | Vacuum pump | ||
5 | Screw | 8 | Screw | 11 | Mounting clip | ||
6 | Electrical wiring harness | 9 | Screw |
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Caution | Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Notes on safety-relevant components | |||
| Remove/install | ||
1 | Release purge line (1) at separation point (2), disconnect, and seal openings with suitable stop plugs. | Record plug | |
2 | Remove screw (5) of coolant line (3). | Bolt, coolant line to coolant thermostat/coolant line holder | |
3 | Unclip electrical wiring harness (6) at retaining clips (11). | ||
4 | Release vacuum line at connection (7), disconnect, and seal openings with suitable stop plugs. | Record plug | |
5 | Remove screw/bolt (8). | ||
6 | Carefully slide electrical wiring harness (6) aside and remove screw (9) underneath vacuum pump (10). | ||
7 | Remove vacuum pump (10). | Installation: Replace elastomer seal of vacuum pump (10). | |
8 | Clean sealing surfaces. | Assembly cleaner | |
9 | Install in the reverse order. | ||
| Check | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of burn injuries, suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust. | Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area. | |
10 | Perform engine test run; in this connection, check engine for proper operation and leak tightness. |
129 589 00 91 00
Record plug