P43.05-2105-09
Shown on model 205 with engine 177 |
1 | Bracket | 4 | Vacuum line | 7 | Bolts | ||
2 | Electrical connectors | 5 | Vacuum pump | 8 | Vacuum hose | ||
3 | Vacuum line | 6 | Heat shield | 9 | Bolts |
5 | Vacuum pump |
10 | Seal |
11 | Driver |
P43.05-2106-11
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Remove heat shield of left and right catalytic converter | ||
2 | Remove upper bracket of right catalytic converter | ||
3 | Detach right catalytic converter from right exhaust gas turbocharger and place to one side | ||
4 | Remove right oxygen sensor downstream of catalytic converter |
| |
Model 205 with engine 177 | |||
5 | Seal bolt hole of oxygen sensor using duct tape | ||
6 | Pull bracket (1) with electrical connections (2) upwards | Model 205 with engine 177 | |
7 | Separate electrical connectors (2) | Model 205 with engine 177 | |
8 | Remove vacuum line (3) | ||
9 | Detach vacuum line (4) from vacuum pump (5) | ||
10 | Unclip electrical lines from right crash plate of right high pressure fuel pump | Model 463 with engine 176 | |
11 | Remove bolts (7) from heat panel (6) | ||
12 | Remove heat panel (6) | ||
13 | Detach vacuum hose (8) from vacuum pump (5) | ||
14 | Remove screw/bolts (9) | Model 463 with engine 176 | |
Model 205 with engine 177Bolt, vacuum pump to cylinder head | |||
15 | Remove vacuum pump (5) | Installation: Note installation position of drive plate (11). | |
16 | Remove seal (10) from vacuum pump (5) | Installation: Install new seal (10). | |
17 | Install in the reverse order |