AR42.80-W-0060B | Determine rear axle load | 26.10.09 |
MODEL 374, 375.1 /3 /4, 930, 932, 933, 934, 940, 942, 943, 944, 950, 952, 953, 954, 957, 958 (except , 375.15)
Only vehicles with wheel configuration 6x2, 8x2
MODEL 375.15
Only vehicles with wheel configuration 6x2, 6x2/2
W42.10-0080-04
1 Test balance
2 Washer
A Distance
1 | Move vehicle so that all wheels are | Supports (2) should be approx. 50 to 60 mm high. The vehicle must be horizontal. The trailing axle or leading axle must be lowered. | |
2 | Secure vehicle at front axle against rolling | ||
3 | Install test balance (1) into garage-pit lifter | Test scale | |
Hydraulic-pneumatic inspection pit lift - over 7.0 t gotis://H_00.9_02.0 | |||
4 | Position test balance (1) at center of drive axle and measure distance (A) | Measure and note down distance (A) from top edge of inspection pit lift to bottom edge of axle housing. | |
5 | Raise drive axle using inspection pit lift and test scale (1) | Only weigh vehicles with test scale (1) when unladen, as otherwise the axle housing may be damaged. | |
Only raise drive axle far enough to enable the supports (2) on the drive axle to be removed. | |||
6 | Remove freed supports (2) | ||
7 | Move inspection pit lift back to noted distance (A) | ||
8 | Read off rear axle load on test balance (1) | ||
9 | Lower rear axle |
385 589 05 21 00
Test balance