1 | Supply line |
L6/3 | Left rear rpm sensor |
L6/3x1 | Rpm sensor connector |
L6/4 | right rear rpm sensor |
L6/4x1 | Rpm sensor connector |
P42.30-2165-04
| Remove/install | ||
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by vehicle manufacturer. | |
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Notes on self-locking nuts and bolts | ||
1 | Switch off ignition | ||
2 | Raise vehicle with vehicle lift | ||
3 | Release and disconnect rpm sensor connector (L6/3x1, L6/4x1) | ||
4 | Expose feed line (1) of rpm sensor (L6/3, L6/4) | To do so, unclip feed line (1) from all cable brackets, open cable ties and remove retaining clamps. | |
Installation: Note installation of lines and route feed line (1) without any tension and chaffing. | |||
5 | Remove bolt and pull out rpm sensor (L6/3, L6/4) | ||
6 | Install in the reverse order | ||
7 | Read out and erase fault memory | ||
| Connect STAR DIAGNOSIS and read out fault memory |