2 | Jam nut |
3 | Adjusting nut |
4 | Cable slack adjuster |
5 | Brake cable |
6 | Release lever |
7 | Guide |
8 | Cable |
S42.20-4536-06
S42.20-4535-09
1 | Pedal assembly | 9 | Electrical connector | 11 | Carrier | ||
5 | Brake cable | 10 | Screw | 12 | Pedal | ||
8 | Cable |
Shown on model 447.7 with engine 654.9 |
11 | Carrier |
13 | Expansion rivet |
14 | Bracket |
S42.20-A000-76
| Remove/install | ||
1 | Release parking brake. | ||
2 | Lift vehicle with vehicle lift. | ||
3 | Mark position of adjusting nut (3) on cable slack adjuster (4). | ||
4 | Release counternut (2) and adjusting nut (3) on cable slack adjuster (4). | Installation: Turn adjusting nut (3) on cable slack adjuster (4) to marked position. | |
5 | Remove brake cable (5) from cable slack adjuster (4). | ||
6 | Remove trim in driver footwell. | ||
7 | Remove cover below instrument panel on driver's side. |
| |
8 | Remove rotary light switch. | ||
9 | Remove expansion rivet (13) and swivel holder (14) out of working area. | Model 447.6/7 with engine 654.9, 780.701 | |
10 | Pull cable (8) rearward and unhook from guide (7) of release lever (6). | ||
11 | Pull out release lever (6) and remove cable (8). | ||
12 | Disconnect electrical connections (9). | Installation: Ensure correct installation position. | |
13 | Remove screws (10). | Bolt, parking brake to bracket on A-pillar | |
14 | Swivel carrier (11) out of working area. | ||
15 | Unhook brake cable (5) from pedal (12). | ||
16 | Unclip brake cable (5) from pedal assembly (1) and remove pedal assembly (1). | Snap-release tool | |
17 | Remove cable (8) from pedal assembly (1). | Only when replacing the pedal assembly (1). | |
18 | Install in the reverse order. | ||
19 | Check adjustment of brake cable (5), adjust if necessary. | ||
| 000 588 05 21 00 Roller brake test stand | ||
Force on parking brake pedal at first notch |
639 589 02 63 00
Snap-release tool