P42.20-2230-06
35 Crossmember
70 Bridge
85 Front brake cable
86 Rear brake cable
92 Cable slack adjuster
94 Return spring
P42.20-2231-07
51 Center assembly suspension
86 Rear brake cable
86c Bracket
86a Rubber grommet
86b Retaining ring
| Remove/install | ||
1 | Remove parking brake shoes | ||
2 | Remove crossmember (35) | | |
3 | Support exhaust system using transmission platform and transmission jack, detach it from rubber retainers and lower | | |
| |||
4 | Loosen, separate and move heat shields or remove them | Depending on accessibility | |
Model 219 except 219.322 | |||
Type 219.322 | |||
5 | Detach retracting spring (94) from bridge (70) | Installation: After installing retracting spring (94): | |
Relieve load on automatic slack adjuster. | |||
6 | Detach front brake cable (85) from automatic cable slack adjuster (92) | ||
7 | Preload automatic slack adjuster (92) | ||
8 | Detach rear brake cable (86) at automatic cable slack adjuster (92) | ||
9 | Unclip rear brake cable (86) from bridge (70) | | |
10 | Pull rear brake cable (86) out of center assembly mount (51) | While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced. | |
Lever rubber grommet (86a) out of center assembly mount (51). | |||
11 | Pull rear brake cable (86) out of wheel carrier | ||
12 | Press together retaining collar (86b) and pull down and out of bracket (86c) together with rear brake cable (86). | ||
13 | Install in the reverse order |
Crossmember and front reinforcement
Snap-release tool
129 589 11 63 00
Workshop equipment
WE58.40-Z-1018-11A | Transmission platform |
WE58.40-Z-1030-11A | Transmission jack |